News

The sand casting surface obtained from the test is complete, but shrinkage cavities are found at the bearing holes of

According to the casting structure and sand casting process, the metal mold for the box and cover is designed. The

According to the comprehensive evaluation results of typical sand casting processes, for the static pressure casting process and V method

Sand casting has different types such as wet sand casting process and non clay sand casting process. The static pressure

Based on the above sand casting process analysis, there are many kinds of materials involved in the sand casting production

Sand casting is a kind of molding method that molten metal into flowing liquid alloy, then burned into the sand

It is found that only a small amount of shrinkage porosity occurs at the inner runner when observing the inside

First of all, it is necessary to conduct solid modeling and mesh division, and then set parameters. This is the

Shrinkage cavity and shrinkage porosity are common defects in sand casting production. The main purpose of numerical simulation of sand

1. Sand casting structure and technical requirements The sand mold casting of the end cover is shown in Figure 1.