gray cast iron

As shown in the table, the mechanical properties of gray cast iron poured in two different heats are shown. It […]

When the rotating speed and feed rate are constant, the cutting length of the cutting edge for cutting each sample

1.Graphite morphology Figure 4 shows the graphite morphology of two groups of gray cast iron samples. It can be seen

When the rotating speed and feed rate are constant, the cutting length of each sample cut by gray cast iron

The influence of reassembly of the same blade at different cutting depths on the cutting force is shown in the

One of the important physical parameters in the process of cutting gray cast iron is cutting force. In the process

In the gray cast iron cutting force measurement test, the different installation position of the turning tool and the sticking

In the process of gray cast iron cutting, the cutting force of gray cast iron directly determines the wear, damage,

Based on the above experimental results, in order to verify the effect of molybdenum on the tensile strength of gray

Molybdenum is an element with strong affinity with carbon, which is conducive to the formation of the second phase particles

According to the different matrix structure, it can be divided into ferrite matrix gray cast iron, pearlite ferrite matrix gray

Graphite parameters such as type, content and length in gray cast iron have an important influence on its tensile strength.

Fig. 1 shows the scanning electron microscope BSE photos of gray cast iron samples with different molybdenum content. It can

Figure 1 and Figure 2 show the microstructure of gray cast iron corroded by 4% Vol. nitric acid alcohol under

Figure 1 shows the graphite morphology of samples S1 ~ S4 in Table 1 observed under scanning electron microscope. According

HT250 finished brake hub produced by ZHY casting is melted in cy-sp35-vim temperature controlled high frequency induction furnace, argon is

The microstructure of primary austenite after heat treatment of four kinds of experimental gray cast iron is shown in the

Gray cast iron wheel hub is one of the important parts of heavy-duty truck. When heavy-duty truck travels down the

Gray cast iron is a low-cost material. It has good thermal conductivity, good mechanical properties and wear resistance due to

As shown in the figure, the hardness and tensile strength results of vanadium titanium gray cast iron with different components